Gnee Steel (tianjin) Co., Ltd
+8615824687445

DC06 Cold Rolled Galvanized Steel Coil

Nov 26, 2025

DC06 Cold Rolled Galvanized Steel Coil

 

Special deep-drawing grade DC06 according to DIN EN 10152

 

DIN EN 10152 specifies electrolytically galvanized, cold-rolled flat steel products for cold forming, including the special deep-drawing grade DC06. The standard defines both the zinc-coating requirements and the fundamental mechanical properties of the steel substrate.

 

When DC06 is electrolytically galvanized in accordance with DIN EN 10152, it receives an additional zinc coating that provides increased corrosion resistance. This protective layer shields the steel against oxidation and significantly extends the service life of components produced from it. The zinc coating can be applied in different thicknesses depending on the intended application, with typical coating ranges between 5 and 20 μm.

DC06 Cold Rolled Galvanized Steel Coil

Importantly, the chemical composition and mechanical properties of the DC06 base material remain unchanged after galvanizing and continue to meet the requirements of DIN EN 10130. As a result, DC06 retains its outstanding cold-formability and mechanical performance, with yield strength, tensile strength and elongation values remaining consistent with those of uncoated DC06.

 

  • DC06 Cold Rolled Galvanized Steel Coil Specification

 

Thickness 0.4mm-1.5mm
Width 500mm-1250mm
Material standard Spcd dc01, dc03, dc04
Inner diameter 508mm
Type Steel Coil
Coil Weight 1-25mt
Technique Cold rolled
Coating weight 30-600g/m2
Inner Diameter 508/610mm

 

Quality Standard Material No.
DC06 DIN EN 10130 1.0873
DC06+ZE DIN EN 10152 1.0873

 

DIN EN Standard Testing direction Yield Point Re
(MPa)
Tensil Strength
Rm (MPa)
Elongation
A80 (in %)
r90 n90
10130 Q ≤ 170 270 – 330 ≥ 41 ≥ 2,1 ≥ 0,220
10152 Q ≤ 180 270 – 350 ≥ 41 ≥ 2,1 ≥ 0,210

 

C
%
Mn
%
P
%
S
%
Ti
%
≤ 0,02 ≤ 0,25 ≤ 0,020 ≤ 0,020 0,3

 

FAQ

 

1. Q: What is the surface quality of DCO6?
A: DCO6 cold-rolled steel typically has a smooth, uniform surface finish. This not only enhances the aesthetic appeal of the final product but also aids in subsequent surface treatments such as painting and coating.

2. Q: Is DCO6 material easy to weld?
A: Due to its extremely low carbon content and minimal alloying elements, DCO6 has good weldability.

3. Q: What is the main difference between cold-rolled and hot-rolled steel?
A: Hot-rolled steel is processed at high temperatures, and its surface is typically rougher and blue-grey. Cold-rolled steel is further processed at room temperature, resulting in a smoother surface, tighter dimensional tolerances, and higher strength.

4. Q: What should be noted during the deep drawing process with DCO6 material?
A: During deep drawing, the grain direction of the steel sheet needs to be considered. Forming perpendicular to the rolling direction is generally safer than parallel to it, and minimal forming radii should be used to avoid cracking.