The surface galvanizing layer of hot-dip galvanized bridge refers to the zinc and zinc-iron alloy layer obtained by hot-dip galvanizing on the surface of the bridge steel.

Zinc layer appearance standards for hot-dip galvanized bridges
The galvanized layer on the surface of the hot-dip galvanized bridge should be smooth without any raised dots. The dots should be in the shape of nodules or zinc thorns. There should be no skin, no missing plating, no residual solution slag, and there should be no zinc nodules or zinc ash. . If the thickness of the galvanized layer on the surface of the bridge is greater than the specified value, dark or light gray uneven color areas are allowed on the surface of the bridge. The appearance inspection of hot-dip galvanized bridges adopts the sampling method.

Repair standards for hot-dip galvanized bridges
If there is a leaky galvanized spot on the surface of the hot-dip galvanized bridge, the zinc leakage surface should be repaired by thermal spraying zinc or zinc alloy fusion. The thickness of the zinc layer after the repair is completed should be the same as the original galvanized layer thickness. Similarly, the oxide film and other contaminants in the missing plating area should be removed before repair to ensure that the new zinc coating is well combined with the iron matrix.
Adhesion standards for hot-dip galvanized bridges
Hot-dip galvanized bridges should not peel or peel in a normal working environment. If artificial bending and deformation occur during use, resulting in peeling and peeling of the galvanized layer, this does not represent the attachment of the zinc layer. If the strength is not good, if Party A requires the adhesion test, it will be negotiated by both parties.
Thickness requirements of zinc layer on the surface of hot-dip galvanized bridge
The thickness of the zinc layer on the surface of the hot-dip galvanized bridge is required to be greater than or equal to 65 microns.





