Gnee Steel (tianjin) Co., Ltd
+8615824687445
Contact Us
  • Mob: +8615824687445
  • Email: ppgi@gescosteel.com
  • Add: No.4-1114, Beichen Building, Beicang Town, Beichen District, Tianjin, China

6005 Aluminium Sheet

Apr 27, 2023

6005 aluminum sheet is an alloy in the wrought aluminum-magnesium-silicon family (6000 or 6xxx series), which is the most widely used type of anti-rust aluminum. It is closely related to the 6005A aluminum alloy, but not the same. The main difference between the two is that the minimum composition percentage of 6005 aluminum in these two alloys is higher than 6005A (while they have essentially the same maximum value). The most common forming method is extrusion.

Aluminum alloy 6005 has properties similar to those of alloys 6106 and 6082 and can sometimes be used interchangeably with them, but 6005/6005A has better extrusion characteristics. The chemical compositions of 6005 and 6005A are different, however, and should not be confused. Alloy 6005 contains significantly higher amounts of silicon, which reduces the melting temperature and improves its extrudability.

Alloy 6005 is similar to alloy 6061. When produced to a -T5 temper, it has the same minimum tensile and yield strength as 6061-T6 and better machinability and strength properties than 6063-T6. Alloy 6005A may also replace 6061 d.

Specifications of 6005 Aluminium Sheet

Aluminium Grade 6005
Material Temper F, O, H112, T4, T6, T651
Thickness (mm) 0.2-500
Width (mm) 20-2650
Length (mm) Customized
Delivery Terms FOB, CFR, CIF

Chemical Composition of 6005 Aluminium Sheet

Elements Si Fe Cu Mn Mg Cr Zn Ti Others Al
Content (max) 0.6-0.9 0.35 0.1 0.1 0.4-0.6 – 0.1 0.1 0.15 97.5-99.0

Common Tempers of 6005 Aluminium Sheet

O – Soft.

T6 – Solution heat-treated and artificially aged.

T4 – Solution heat-treated and naturally aged to a substantially stable condition.

T651 – Solution heat treated, stress relieved by stretching then artificially aged.

T6511 – Solution heat-treated, stress-relieved by controlled stretching and minor straightening is allowed after stretching to comply with standard tolerances then artificially aged.

6005 T6 Aluminium Sheet