Anodizing Process Of 6063 Aluminum
But what is anodized aluminum? In a few words, anodizing is a process used to increase the oxide layer on the surface of aluminum. Then, a hard, wear-resistant protective layer is created. Let's explain the process in more detail:
Anodizing is an electrolytic process, i.e. it uses electrical current to produce electrolytic reactions, including anodic oxidation and cathodic reduction. It is at this point that the aluminum anode is almost completely covered by the aluminum oxide film.
During anodization, the thickness of the surface oxide layer increases. Its structure and characteristics can be modified according to the following changes:
Properties of Electrolytes
Its composition
Its temperature
Healing period
Voltage used
The process of adnized
6063 VS 6061
Two common variants of 6000 series aluminum alloys are 6061 and 6063.Both of them are widely used, but what is the specific difference?
| Chemical Composition | In terms of Mg and SI, 6061 is 30-50% more than 6063. The most direct effect is that 6061 has a greater strengthening effect than 6063. |
| Mechanical Properties | The strengthening effect of 6061 heat treatment is greater. In contrast, the higher the tensile strength, the greater the deformation resistance, so the plasticity of the 6061 alloy is lower than 6063. |
| Plasticity | 6061-T6 is used in occasions that require certain strength and hardness. 6063 is a representative alloy for extrusion with good extrudability. |
| Other Aspects | Surface treatment: Both 6061 and 6063 anodizing properties are very good. 6063 aluminum is better.
Machinability: Both are good. 6061 is better. |
In a few words,6061 aluminum offers higher strength and workability than 6063 aluminum, but 6063 has better extrudability.
Packaging Of 6063 Alloy Anodized Aluminum
